Torna a NXP Semiconductors

NXP Semiconductors Driver LED a corrente costante 57 mA I2C-bus Fm+ a 16 canali PCA9952

Il driver LED a corrente costante 57 mA I2C-bus Fm+ a 16 canali PCA9952 di NXP ottimizza l'oscuramento e il lampeggiamento dei prodotti da gioco a LED RGBA (rosso, verde, blu, ambra) da 57 mA. L'uscita di ogni LED dispone di un proprio controller PWM a frequenza fissa con risoluzione a 8 bit autonoma (256 fasi) e funzionamento a 31,25 kHz con un ciclo utile regolabile da 0% a 99,6%. Ciò consente di impostare il LED su un valore di luminosità specifico. Un ulteriore controller PWM di gruppo con risoluzione a 8 bit (256 fasi) offre sia una frequenza fissa di 122 Hz che una frequenza regolabile da 15 Hz a una volta ogni 16,8 secondi, con un ciclo utile regolabile da 0% a 99,6% utilizzato sia per l'oscuramento che per il lampeggiamento di tutti i LED con lo stesso valore.

The PCA9952 has a Fast-mode Plus (Fm+) I2C-bus interface. Fm+ devices offer higher frequency (up to 1MHz) or more densely populated bus operation (up to 4000pF).

The PCA9952 is identical to PCA9955 except for the following differences:

  • The PCA9952 has only three hardware address pins compared to four on PCA9955
  • The PCA9952 has an output enable pin (OE) and the PCA9955 does not

The active LOW output enable input pin (OE), available only on PCA9952, blinks all the LEDn outputs and can be used to externally PWM the outputs, which is useful when multiple devices need to be dimmed or blinked together without using software control.

These devices have built-in open, short load and overtemperature detection circuitry. The error information from the corresponding register can be read via the I2C-bus. Additionally,na thermal shutdown feature protects the device when internal junction temperature exceeds the limit allowed for the process.

Caratteristiche

  • 16 LED drivers. Each output programmable at:
    • Off
    • On
    • Programmable LED brightness
    • Programmable group dimming/blinking mixed with individual LED brightness
    • Programmable LEDn output enable delay to reduce EMI and surge currents
  • 16 constant current output channels can sink up to 57mA, tolerate up to 40V when OFF
  • Output current accuracy
    • 6% between output channels
    • 8% between PCA9952/55 devices
  • Open/short load/overtemperature detection mode to detect individual LED errors
  • 1MHz Fast-mode Plus compatible I2C-bus interface with 30mA high drive capability on SDA output for driving high capacitive buses
  • 256-step (8-bit) linear programmable brightness per LEDn output varying from fully off (default) to maximum brightness using a 31.25kHz PWM signal
  • 256-step group brightness control allows general dimming (using a 122Hz PWM signal) from fully off to maximum brightness (default)
  • 256-step group blinking with frequency programmable from 15Hz to 16.8s and duty cycle from 0% to 99.6%
  • Output state change programmable on the Acknowledge or the STOP Command to update outputs byte-by-byte or all at the same time (default to 'Change on STOP')

Applicazioni

  • RGB or RGBA LED drivers
  • LED status information
  • LED displays
  • LCD backlights
  • Keypad backlights for handheld devices
  • Automotive lighting

Related Products

NXP Semiconductors PCA9955 16-channel Constant Current LED Driver

I2C-bus controlled driver optimized for dimming & blinking 57mA Red/Green/Blue/Amber (RGBA) LEDs.

Learn MoreInformazioni su NXP Semiconductors PCA9955 16-channel Constant Current LED Driver View ProductsCorrelato a NXP Semiconductors PCA9955 16-channel Constant Current LED Driver

Block Diagram

Schema a blocchi - NXP Semiconductors Driver LED a corrente costante 57 mA I2C-bus Fm+ a 16 canali PCA9952

Pin Designations

Disegno meccanico - NXP Semiconductors Driver LED a corrente costante 57 mA I2C-bus Fm+ a 16 canali PCA9952
Pubblicato: 2013-11-22 | Aggiornato: 2022-03-11